CLASSIFIEDS > Suspension & Steering

FOR SALE HYDRO ASSIST RAM AND STEERING BOX

<< < (2/3) > >>

kvom:

--- Quote from: tjsahara00 on January 07, 2013, 08:19:32 AM ---So thats all I would need?

--- End quote ---

Welding skills  ;D

You would need to determine attachment points/methods for the axle and tie rod, which can be different according to axle and steering setup.  If too different, you may need to get new hoses.

Also, get caps to seal outlets on steering box, so that if a hose or the cylinder craps out on the trail, you can close off the box and drive it out (after refilling the PS fluid).

tcdawg:

--- Quote from: tjsahara00 on January 07, 2013, 08:19:32 AM ---So thats all I would need?

--- End quote ---
Good deal here Kevin for a TJ guy!

BDDISI:

--- Quote from: tjsahara00 on January 07, 2013, 06:10:57 AM ---Sammy,
 Is that everything I would need? Do you have to have a different pump, reservoir etc....

--- End quote ---

This will work with your stock pump. You will want to get a fluid cooler.  I run a 14in sink type cooler.  The only thing I did to my stock pump was put a PSC pulley on it, it helped the pump at lower rpms.

BDDISI:
I am selling this cause I am making some changes.  A few preview pics.

BDDISI:
I also will not be using my front Currie Antirock sway bar.  It is for sale also.  $200.00

Navigation

[0] Message Index

[#] Next page

[*] Previous page