Aenta in October 11th

[lt99ls1]

  Need some info where this cracker barrel is located and motel info. Any one want to go in on a room?
  Mark

9:30 @ the Cracker Barrel @:
50 Birmingham Hwy
Chattanooga, TN 37419
(423) 825-5885

[NOS/86]

i think i'm going to try and make this ride .   ;D    is it going to be ok to bring my cooler of miller light ??   

[JBC]

i think i'm going to try and make this ride .   ;D    is it going to be ok to bring my cooler of miller light ??   

I am defiantly bringing a few cold ones!  Seems I normally need a drink after watching you and Larry.

[lt99ls1]

99% sure I will be in the TJ. IT will not be stretched in time for this ride. Waiting on parts, so I put her back together tonight.

[47knucklehead]

  Need some info where this cracker barrel is located and motel info. Any one want to go in on a room?
  Mark

9:30 @ the Cracker Barrel @:
50 Birmingham Hwy
Chattanooga, TN 37419
(423) 825-5885

  Thanks Guy

[broncofire75]

Got the front driveshaft today and the hitch done. Installing it all that and the leaf packs today. Ill be ready to go.

[dcallaway]

I got the yeep put back togeather today.I am ready.

[Chris Hyde]

Driveline vibes?

[broncofire75]

Who me? Nope SYE!

If not me then oh well.

Got bashed on NAXJA about the welds on my hitch but Ive seen some pretty gnarly welds that hold up and a gorilla welded(looks like shit but holds like a gorilla) mine. Ill be aight I reckon. I dont think I did too bad for it being the first build Ive done all by myself.

Welder was set at 20 and 395ish. Recommended 1/4" welding on the Miller 251 I used. Oh well.

[ranger11]

Man if it was welded twice you will not be able to see the botoom weld. I always try to put as much stress on my welds as I can before I use the item. I say hook it to a tree and snatch not too hard but enough to know it will either break or hold up. Or have someone hook a wench cable and pull you in park. Either would put alot of stress on the whole assembely.


Ps post the link next time it took me forever to find yo post

[lt99ls1]

Made a new rear drive shaft, installed a new trans filter, trans gasket, straighten the belly up skid plate (nothing like droping a truck on the bely up to fix it  ), tighting the trans mount and mounted the York.

[Xterra]

ima try and make this ride also. waiting for new winchline for jeep and softtop. if it comes in time, im definitely game.