**FOR SALE**NEW**ARTEC Dana 44 Wagoneer MODULAR Rear Truss

[ACGiddens]

Never used

Dana 44 Wagoneer MODULAR Rear Truss-$149.99-Retail w/ Spring Perch Ends -$49.99-retail



I picked up some waggy 44's cheap and then someone made me an offer on them I couldn't refuse.

I have no use for it at the moment

For Sale @ $160.00

Prefer not to ship, but can on your dime.

PM or E-mail with any questions
adamgiddens89@gmail.com

[Krawler00]

Just curious, what is the difference in a waggy rear 44 over a standard 44 tj etc? I was thinking all 44 rears were the same.

[ACGiddens]

The waggy 44 is offset by like 2"-3" from center im pretty sure. The TJ 44 is centered. The axle tubes are just slightly larger on the waggy's as well.

[Krawler00]

Did not know that. Cool.

[hb_hound]

$125.00 and I will pick it up Tues of next week??????

[ACGiddens]

PM'd {pm}

[hb_hound]

PM'd {pm}

Reply sent

[JROLIN]

2 available at this price.

[Danny Kinder]

2 available at this price.

 //LURKING//

[Mortalis5509]

The waggy 44 is offset by like 2"-3" from center im pretty sure. The TJ 44 is centered. The axle tubes are just slightly larger on the waggy's as well.

The tj 44 is not centered. I have twisted splines and broken shafts enough to know. One shaft is longer than the other and will not fit on the short side. ATM i forgot which is the long side.

If the waggy is full width it might only need some trimming to fit the tj. Give artec a call or pm the guy on pirate.

[ACGiddens]

From Artec's site:

http://www.artecindustries.com/Dana-44-Axle-Truss-CenteredFull-Width_p_305.html
"The Jeep TJ Rubicon Rear Dana 44 has a centered differential housing that measures approx. 15" and the axle tube diameter is 2.625 inches. Other Dana 44's will measure differently and have differing axle tube diameters. Please ensure your axle meets these dimensions prior to ordering. Can be easily modified to fit larger tube diameters. Regardless, the axle should have NO STOCK BRACKETRY for this truss to work."

http://www.artecindustries.com/Dana-44-Wagoneer-MODULAR-Rear-Truss_p_227.html
"The Jeep Wagoneer Rear Dana 44 has about 18 inches of axle tube on the driver side and about 20 inches of passenger side axle tube. The axle tube diameter is 2.75 inches. Other Dana 44's will measure differently and have differing axle tube diameters. Please ensure your axle meets these dimensions prior to ordering."

[Mortalis5509]

From Artec's site:

http://www.artecindustries.com/Dana-44-Axle-Truss-CenteredFull-Width_p_305.html
"The Jeep TJ Rubicon Rear Dana 44 has a centered differential housing that measures approx. 15" and the axle tube diameter is 2.625 inches. Other Dana 44's will measure differently and have differing axle tube diameters. Please ensure your axle meets these dimensions prior to ordering. Can be easily modified to fit larger tube diameters. Regardless, the axle should have NO STOCK BRACKETRY for this truss to work."

http://www.artecindustries.com/Dana-44-Wagoneer-MODULAR-Rear-Truss_p_227.html
"The Jeep Wagoneer Rear Dana 44 has about 18 inches of axle tube on the driver side and about 20 inches of passenger side axle tube. The axle tube diameter is 2.75 inches. Other Dana 44's will measure differently and have differing axle tube diameters. Please ensure your axle meets these dimensions prior to ordering."

All well n good and what not but they are wrong about the tj Rubi axle. I have an 04 rubicon and the shafts are not the same length. I promise. I'm not trying to argue with you and I know you copied and paste that but I have changed and pulled them multiple times.