Georgia Trail Riders Forum

CLASSIFIEDS => Random Stuff => Topic started by: hb_hound on September 09, 2014, 06:05:31 PM

Title: SOLD
Post by: hb_hound on September 09, 2014, 06:05:31 PM

IIRC it is a ProBender3
Very little use, includes bender and 1-3/4" 240* Die (6 CLR)
20ft 1-3/4" DOM Tubing
$600.00

Title: Re: Tube Bender
Post by: clark123456 on September 09, 2014, 06:31:06 PM

interested...any pictures?

Title: Re: Tube Bender
Post by: hb_hound on September 10, 2014, 07:33:39 AM

Best one I have right now
(http://i42.photobucket.com/albums/e329/mellis123/bender.jpg) (http://s42.photobucket.com/user/mellis123/media/bender.jpg.html)

Title: Re: Tube Bender
Post by: Digger on September 10, 2014, 08:06:04 AM

Interested as well.  Where are you located?

JB

Title: Re: Tube Bender
Post by: hb_hound on September 10, 2014, 10:28:23 AM

Located in Grayson off 78 between Snellville and Loganville

Title: Re: Tube Bender
Post by: clark123456 on September 10, 2014, 02:35:12 PM

I am still researching benders, so do not hold out for me to come around.  First cash should be first to get it...IMHO.

Title: Re: Tube Bender
Post by: kvom on September 10, 2014, 03:21:40 PM

Does this bender allow greater than a 90-degree bend?  A question that anyone with a current project should be aware of.

Title: Re: Tube Bender
Post by: bjeep on September 10, 2014, 04:20:39 PM

Quote from: kvom on September 10, 2014, 03:21:40 PM

Does this bender allow greater than a 90-degree bend?  A question that anyone with a current project should be aware of.

The add states 240* degree. So I would say yes.

Looking at the Die I would say it will do 180*  plus

Title: Re: Tube Bender
Post by: 94xjsport94 on September 10, 2014, 04:40:14 PM

The website says it'll do 180* bends. The die is 240*

http://www.probender.com/probender/drupal/product/pro3-hydraulic-tube-bender (http://www.probender.com/probender/drupal/product/pro3-hydraulic-tube-bender)

Title: Re: Tube Bender
Post by: 94xjsport94 on September 10, 2014, 04:47:36 PM

I'd rather have a thumb control than a ball valve, but the 90* bend without moving the die pin is nice.

Title: Re: Tube Bender
Post by: hb_hound on September 10, 2014, 05:11:51 PM

Yes, it will do 180* bends.

Available to GATR first, adding to additional sites tomorrow afternoon.

Title: Re: Tube Bender
Post by: 94xjsport94 on September 10, 2014, 05:52:54 PM

I'd probably buy it if I hadn't already done 78% of my cage. I do have some other things to do, but seems like a good deal.

Title: Re: Tube Bender
Post by: hb_hound on September 11, 2014, 09:45:51 AM

SOLD - pending pick-up