Georgia Trail Riders Forum
CLASSIFIEDS => Interior => Topic started by: kent10sne1 on April 22, 2016, 10:44:32 AM
-
http://www.carolinametalmasters.com/products/cmm-jk-billet-front-grab-handles (http://www.carolinametalmasters.com/products/cmm-jk-billet-front-grab-handles)
My new cage has grab handles built in and these had to come off for it to fit. Retail 160. no scratches, all hardware to install driver/pass.
club price = $80 will wait a week and then post on other forms.
(http://i275.photobucket.com/albums/jj315/kent10s/CMMGrabHandles.jpeg.png)
-
Good deal! What cage did you go with ?
-
PS seemed the more sturdy route.
-
Where are you moving the switches to? Mine are in the same location.
Welded cage or bolt together?
-
I was thinking / looking for a switch plate that would mount up on the bar or maybe on the lower left driver where the speaker is, or maybe under the AC control..its empty in that location..
-
The spod panel will fit nicely on the dash center under the other switches.
http://www.4x4spod.com/category_s/12.htm (http://www.4x4spod.com/category_s/12.htm)
it would be nice if there was a way to mount the rugged ridge panel below the center switches.