Georgia Trail Riders Forum

CLASSIFIEDS => Interior => Topic started by: kent10sne1 on April 22, 2016, 10:44:32 AM

Title: CMM jk billet front grab handles
Post by: kent10sne1 on April 22, 2016, 10:44:32 AM

http://www.carolinametalmasters.com/products/cmm-jk-billet-front-grab-handles (http://www.carolinametalmasters.com/products/cmm-jk-billet-front-grab-handles)

My new cage has grab handles built in and these had to come off for it to fit.   Retail 160.  no scratches, all hardware to install driver/pass.

club price = $80  will wait a week and then post on other forms.

(http://i275.photobucket.com/albums/jj315/kent10s/CMMGrabHandles.jpeg.png)

Title: Re: CMM jk billet front grab handles
Post by: Jeepster1407 on April 22, 2016, 11:52:10 AM

Good deal! What cage did you go with ?

Title: Re: CMM jk billet front grab handles
Post by: kent10sne1 on April 22, 2016, 12:02:18 PM

PS seemed the more sturdy route. 

Title: Re: CMM jk billet front grab handles
Post by: Blue J on April 22, 2016, 01:01:45 PM

Where are you moving the switches to? Mine are in the same location.

Welded cage or bolt together?

Title: Re: CMM jk billet front grab handles
Post by: kent10sne1 on April 22, 2016, 01:19:20 PM

I was thinking / looking for a switch plate that would mount up on the bar or maybe on the lower left driver where the speaker is, or maybe under the AC control..its empty in that location.. 

Title: Re: CMM jk billet front grab handles
Post by: Blue J on April 22, 2016, 03:04:07 PM

The spod panel will fit nicely on the dash center under the other switches.

http://www.4x4spod.com/category_s/12.htm (http://www.4x4spod.com/category_s/12.htm)

it would be nice if there was a way to mount the rugged ridge panel below the center switches.