Georgia Trail Riders Forum
MEMBERS DISCUSSION AREA => General Discussion => Topic started by: Mortalis5509 on April 04, 2017, 12:59:07 PM
-
So every spring I repaint half the walls and fill in any dings in the wall. Always use flat so you can't tell I do it.
So I have this small area where bleed through occurs. Looks like something is split and runs down the lower portion of the wall. Its been painted a few times. Use primer + paint every time, behr ultra. It bleeds through before the year is out. What would cause that? No other issue anywhere is the house. Light medium brown...called harvest brown I think.
Sent from my SM-G935V using Tapatalk
-
Oil base Kilz is the only thing I know besides sheet rock replacement that will stop bleed through. Dark oil base paint causes bad bleed through. Do not be suckered into the water base kilz BS.
-
I was thinking along with Jimbo on this one...
-
If she's bleeding through the wall you should find a different place to put the dead hooker.
I'll ask the Sherwin-Williams rep living in my house for the next two weeks. Any pics to share?
(https://uploads.tapatalk-cdn.com/20170404/5bac9f3a7d2744283c73d7c32d215faf.jpg)
That's most of it.
This is the paint I use. Again this one wall in the entire house. There is no water source near by. Sheetrock isn't soft.
(https://uploads.tapatalk-cdn.com/20170404/fdc1762ffbbe5c25852d6d84187f6ef6.jpg)
Sent from my SM-G935V using Tapatalk
-
Is that an exterior wall or near an attic fan/ladder? Any reason humidity would sweat there? e.g. humid cold air from a vent blowing on a warm wall or vice versa.
Intererior wall. On the other side is the dinning room. (https://uploads.tapatalk-cdn.com/20170404/879d4f4d5fe1313c2f7361fcc7a19dbe.jpg)
It's the wall with the plug and switch on iy.
Sent from my SM-G935V using Tapatalk
-
Kilz it and it won't come back
Sent from my Pixel XL using Tapatalk
-
Either Kilz it and/or if that doesn't work then it is most likely a polter-goose. Fixed only with a sledge hammer and new drywall. If it comes back after that, move.