I mounted mine overhead. It is easy to access, hear and is out of the way.
Real, real easy and cheap.
1. Take the top down and measure the width of your interior from the top of roll bar to top of roll bar, at the location where the hard top freedom panels have a small peg that fits down in the roll bar tube
2. Go to HD or Lowes and by some 1X1 steel stock the length you need
3. Trim it to the exact length and cut out some "ears" on each end so the steel stock fits on top of the roll bar tube.
4. Attach it with a selt tapping screw or you can put it right in the location of the hold in the roll bar tube if you are not using a hard top and use a bolt.
5. once you have everything fitted, take it off and paint it, screw on your CB mount and your done
This was a very sturdy mount.
bad pics but it should help you a little
![](http://i68.photobucket.com/albums/i32/TChaap/3b4c1041.jpg)
![](http://i68.photobucket.com/albums/i32/TChaap/9532be22.jpg)