Welding table
Had to buy it myself, inbound. Hope to weld it up in a couple weeks
Which one did you get?
One from here, http://weldtables.com
I've heard they build to order, so it might take some time.
Also, kinda new to the game...
Thicker would of been better, but for the small projects I do should be fine
Yeah, mine is 1/2" steel plate that is 4' x 4'. I welded the top to 2" (3/16") square tube with 2" (again, 3/16") angle iron supports along the bottom, and 4 big ass casters...it is freaking heavy as hell...and it was very expensive! IF I had it to do over again, I don't know that I would do what I did; I nearly lost a limb just getting the plate out of the bed of the truck...I shouldn't have done it alone.
Those slots should be awesome for blocking out and squaring your projects. If you don't already have them, get a lot of clamps of various sizes. I also use the magnetic angle pieces (usually red and look like arrows with the point missing) a lot...very nice to have around.
Good luck...be sure to post up some of your creations.