2 2" 1-3/4" pieces of tube

[94xjsport94]

I need to rebuild my bumpstop towers and do it the right way so I can stop using hockey pucks and softballs. I need (2) 2" pieces of 1-3/4" tube .120 wall or bigger. It'll probably be easier to ship them to me. I can paypal you a few bucks. Prefer DOM or HREW. Thanks!

[clark123456]

I think I have some smaller tube (maybe bigger; whatever is on my stinger), if you decide you can live with 1.5" or 2" (or whatever it is I used on the stinger), let me know.

[94xjsport94]

I think your stinger is 1.5". I'll see if I can get any scrap 1.75, if not I'll hit you up

[Scott F.]

Will, I've got 1.75" .120 wall and 2" .120 wall.  So you only need two pieces 2" each, or do you want a little extra to cut to exact length. Too bad your not closer or you could just pick it up. I can box it up and ship if you need it soon.

[94xjsport94]

2" length should be good for what I'm using, a hair longer is fine though. I believe 1.75" should be good, 2" would work as well. I'll measure again and see which size would be best.

[Scott F.]

Looks like the last of my 1.75 x .120 wall was used on my cage, the 1.75 I have left is all .095 wall. I have lots of scraps of 2" x .120 wall left over so hopefully that size will work better than 1.75"

[94xjsport94]

I measured again, it needs to be 1.75".

As far as wall thickness, it is going to be part of a bumpstop, so I figured .120 would be a minimum. Someone on NAXJA might have a scrap piece for me.