Tj dana 30 parts

[cudruln]

Rcv not from me in a 30. That can be saved for the one tons, if that ever happens. But I see myself staying with most of my current setup for a good while. I am just going to keep doing some research and try to find a good setup that will work for my needs.

What should hp30 cost?

Sent from my GT-P7510 using Tapatalk

[94xjsport94]

That's just my .02. I would run stock shafts with a Spicer 760x u joint with full circle clip if i didnt already have my chromos. I'll take the time to replace a shaft over a gear set any day.

[clark123456]

Rcv not from me in a 30. That can be saved for the one tons, if that ever happens. But I see myself staying with most of my current setup for a good while. I am just going to keep doing some research and try to find a good setup that will work for my needs.

What should hp30 cost?

Sent from my GT-P7510 using Tapatalk

I picked mine up at a pull-a-part store for roughly $175, plus my wrench time.  Will could probably hook you up with a coupon code for some place near him for <$75...he operates that way.

[BlueJew]

No full clip on stock axles is what I was told by alloy USA.  That's why I had my caps tacked down as I almost lost one in harlen when the c clip came out

[clark123456]

No full clip on stock axles is what I was told by alloy USA.  That's why I had my caps tacked down as I almost lost one in harlen when the c clip came out

I think that is due to you rocking the awesome d44.  Us pathetic d30 guys get clips.

[94xjsport94]

You have to grind them to accept full clips. I can post a write up when I get home tonight, but it's possible. Tacking the caps works too, but can make for a PITA in the wrong situation.

[94xjsport94]

As promised. Ah the blue Prius..
http://www.cherokeeforum.com/f46/blue-prius-131319/index12/?styleid=6