Author Topic: SOLD (Read 2274 times)

hb_hound · « **on:** September 09, 2014, 06:05:31 PM »

IIRC it is a ProBender3
Very little use, includes bender and 1-3/4" 240* Die (6 CLR)
20ft 1-3/4" DOM Tubing
$600.00

clark123456 · « **Reply #1 on:** September 09, 2014, 06:31:06 PM »

interested...any pictures?

hb_hound · « **Reply #2 on:** September 10, 2014, 07:33:39 AM »

Best one I have right now

Digger · « **Reply #3 on:** September 10, 2014, 08:06:04 AM »

Interested as well. Where are you located?

JB

hb_hound · « **Reply #4 on:** September 10, 2014, 10:28:23 AM »

Located in Grayson off 78 between Snellville and Loganville

clark123456 · « **Reply #5 on:** September 10, 2014, 02:35:12 PM »

I am still researching benders, so do not hold out for me to come around. First cash should be first to get it...IMHO.

kvom · « **Reply #6 on:** September 10, 2014, 03:21:40 PM »

Does this bender allow greater than a 90-degree bend? A question that anyone with a current project should be aware of.

bjeep · « **Reply #7 on:** September 10, 2014, 04:20:39 PM »

Does this bender allow greater than a 90-degree bend? A question that anyone with a current project should be aware of.

The add states 240* degree. So I would say yes.

Looking at the Die I would say it will do 180* plus

94xjsport94 · « **Reply #8 on:** September 10, 2014, 04:40:14 PM »

94xjsport94 · « **Reply #9 on:** September 10, 2014, 04:47:36 PM »

I'd rather have a thumb control than a ball valve, but the 90* bend without moving the die pin is nice.

hb_hound · « **Reply #10 on:** September 10, 2014, 05:11:51 PM »

Yes, it will do 180* bends.

Available to GATR first, adding to additional sites tomorrow afternoon.

94xjsport94 · « **Reply #11 on:** September 10, 2014, 05:52:54 PM »

I'd probably buy it if I hadn't already done 78% of my cage. I do have some other things to do, but seems like a good deal.