Craigslist/Good Deal Thread

[DOUG]

I'm thinking scam

[Raisinhead]

http://atlanta.craigslist.org/atl/cto/5248748970.html

Damn, I almost bought it just because it was so cheap.  I hope a GATR got it.

- Torg

That's a deal. Wish it 5k axles!

[lt99ls1]

I'm thinking scam

Correct it was.

[kvom]

http://atlanta.craigslist.org/nat/tls/5253306545.html

Shop press $50 Jasper

[tcdawg]

http://atlanta.craigslist.org/atl/cto/5250740522.html

[DOUG]

Dang LJ is a steal.  I bet its gone or he will raise the price when he is over run with emails.  I'm trying.

[BeerIAm]

Wish I had a Silverado laying around to give him

[lt99ls1]

IMHO this is a damn good deal.

[DOUG]

@lt99ls1 Larry, or @Mortalis5509

Does that front have enough room for a spring perch or are you forced into coil overs or ORI's/etc?

IS that a 60 or 70 or 10.5 rear?

[Mortalis5509]

@lt99ls1 Larry, or @Mortalis5509

Does that front have enough room for a spring perch or are you forced into coil overs or ORI's/etc?

IS that a 60 or 70 or 10.5 rear?

He linked you something above, but those year model trucks use coil springs. May could use the stock perch, pending the coil fit in it properly. The driver side doesn't have a lot of exposed tube, but you can make something happen.

I have a jrat 69 housing. Could reuse everything from those axle but with a lot less weight and even more clearance.

[lt99ls1]

The 05 and up superduty fronts have alot of space the drivers side, think 78-79 snowfighter dana 60 but with more beef.

I would still try and haggle with the guy on the price just to see if he has any wiggle room.

Front, rear, wheels, 241or case and at least the front truss.

[94xjsport94]

I'm running coils with mine... Stock coils mount with a bucket off the inner C so it would end up being pretty tall going that route. I also think the stock Ford springs taper down to a small coil both ends. Just cut some of the cast back and you can easily mount a coil and link.