Skyjacker transfer case bracket...

[Krawler00]

Okay, I got the bracket on this morning after having to do some serious rework on the design. Apparently the bracket was made for automatic transmissions and nobody cared to make one for the manual. In short if you buy this you will need to drill 2 holes to slide one half of the bracket over and use some spacers to get it to cleaar the bracket when pulling into 4 lo. No mention of it on any writeups or in the instructions. And yes... there is only 1 way it can be put on. Just so you all know! Took 2 hours which should have been maybe 45. Alot of work for $60!!

[DOUG]

Man, you're good.  When can I drop off the TJ ;D and the Gas Tank Skid for install?

[Krawler00]

You can't afford me! ;D

[DOUG]

I thought you said $60 for 2 hours! 

[Krawler00]

HUH? You smokin that pipe again?

[DOUG]

Took 2 hours which should have been maybe 45. Alot of work for $60!!

I knew you said it!

[Ben H.]

Is this a drop bracket or something else?

[Will]

There are two separate designs, one for auto and one for manual. Only reason I know is cause Quadratec sent me the manual bracket first.  As long as it fits 

[Krawler00]

Doug, I meant $60 for the part. As for the bracket, they may have sent the wrong bracket but, they are identical looking. But obviously not when you go to install it!