Trail Corners and 4" LED lights

[Will]

Looking for a set of 4" Round LED stop/turn/tail lights.

Trail corners. Preferably short style, but if the price is right I'll look at full corners . Mostly just to cover up some damage, but would like to get some protection too. Would also like them to be 3/16" thick, but smaller will do.

Thanks,
Will

[DOUG]

Looking for a set of 4" Round LED stop/turn/tail lights.

Trail corners. Preferably short style, but if the price is right I'll look at full corners . Mostly just to cover up some damage, but would like to get some protection too. Would also like them to be 3/16" thick, but smaller will do.

Thanks,
Will

I thought you were going to bend us up some!

[Will]

I thought you were going to bend us up some!

Didn't get it done. I'm leaving for school this weekend and I don't want to wait til next summer. I've still gotta sand blast and repaint my rear bumper, weld a new antenna mount to my bumper, and cut on the 8.8 a little so it doesn't cut into my gas tank skid and annoy the piss out of you again  ;D.

I seriously just didn't have time for any Jeep stuff this last half of the summer. We've been super busy at work. We owe all that to Duracell, but at least they pay good    So I get this one week off to get all my crap ready for school and fix all the crap wrong with the Jeep before I go. I wish I had time to build all my skids like I planned, but I only really got the new lift and 8.8 done.

[yellowxj]

Just snooped around for a sec. Didnt remember who makes short 3/16" corners....found some full 3/16 for $225 but they havent been produced yet...I dont know why they publish stuff in cataloges thats not in production..

[Krawler00]

Travis, you still have those round rear led lights!? I still want a set!!

[DOUG]

I saw some cool lights on Extreme4x4 recently, but they are all pricey.  I want to do the corners and LED's together, so I'll start looking for a deal.

[yellowxj]

Travis, you still have those round rear led lights!? I still want a set!!

Yep. Got some still. Got one set of those mounts powder coated too...they look great...still dont know what to do with them though.

[Will]

http://www.4wd.com/productdetails.aspx?partID=14596

Probably end up getting something like this. Those OROs are just DUMB!

I want to get the Rokmen 3/16" short corners but they'll be on back order forever it seems. I may just end up ordering these, even though I think it's pretty pricey for what it is.

http://www.quadratec.com/products/12525_300.htm

[DOUG]

http://www.4wd.com/productdetails.aspx?partID=14596

Probably end up getting something like this. Those OROs are just DUMB!

I want to get the Rokmen 3/16" short corners but they'll be on back order forever it seems. I may just end up ordering these, even though I think it's pretty pricey for what it is.

http://www.quadratec.com/products/12525_300.htm

I've got to upgrade from the plastic band aid I have on mine now.  I want to go full corners, LED's, and tube fronts at the same time.  I'm not sure which look I like the most, flares or no flares, and comp cut or standard.  I think this red jeep has it right:

[Will]

That second one is super clean.

[Jimmy]

Just get the $8 incadescant ones! Mine seem brighter from a few feet than LED ones anyway.

[RotorHead]

That second one is super clean.

x2.  The second one is bad azz. Who makes that?