Need advice and opinions!

[Confederate]

I wouldnt go over .030" Makes the cylinder walls thin and can cause over heating more easily. Plus leave a little meat just in case. you have to rebuild in the future.  Good thing is the 460 block has a thick casting and can be bored quite a bit up to .125".

You should get an 806 stroker kit  ;D
http://www.rpmmachine.com/ford-460-806-stroker.shtml

Tewo words about the link you posted..


HOLY SCHNIZZLEZ

[Confederate]

Well I got the whole thing apart. Crankshaft fell down though but landed on my finger and leg on the side and hit a tire (with rim) but thank God it didn't hit the concrete or fell from a high high place.

Maybe it isn't bent.

Ok. NAPA guys asked me what pistons am I going to use.I told him I don't know.

So, I need yall to pick out some parts I should install in my 460 to make it a good beast, if yall are willing to do this for me! I am wanting some good hp and torque

I am planning to get my stuff from Summit Racing and get the Bill me Later option. My budget is around 1,000-2,000 dollars. I plan to get the 360 bill me later day thing that Summit has.

Could you make a list?


THANKS!