WTB D-30

[Rowingfish87]

how about this for a front axle:

http://www.southernjeeps.org/phpbb/viewtopic.php?t=30545

with these:

http://www.southernjeeps.org/phpbb/viewtopic.php?t=30546

and these:

http://ballisticfabrication.3dcartstores.com/Link-bracket-coil-spring-shock-mount-combo_p_1461.html


now i just need to come up with the money to buy it...

your thoughts?

[Jimmy]

I think the Bronco axle is wider than the Jeep axle, so getting 5x5.5 wheels and running an adapter on the rear would probably be better. Don't forget you need upper link mounts also!

[ranger11]

Thats a good deal but its low pinion. Which if I would have known I would have put a lp 60 in the ranger just so I didnt have to worry about u-joints. I say go for it

[ranger11]

Jimmy this is from the smaller broncos I think the width should be pretty close to a jeep. I know this "THE" axle for a ranger because of the width most of the time they are around 500-600.

[Jimmy]

Well, if it works doooo eeeet.

[Rowingfish87]

Jimmy this is from the smaller broncos I think the width should be pretty close to a jeep. I know this "THE" axle for a ranger because of the width most of the time they are around 500-600.

Yeah I think they are 58" wide and ithe stock jeep is 60.5(?) But if the front ends up being a little wider I'll just buy some wheel spacers for the rear.

Any other thoughts/suggestions if I go through with this?